| Provide
us with your engineering drawing or use the extrusion tip and
die drawing below to communicate the dimensions you require. If
you do not have a drawing, follow these steps:
1.
Use this specification sheet as a master. Copy the drawing and
enlarge them as needed for work sheets or orders.
2.
Find the drawing that represent the extrusion tip or die best
suited for your application.
3.
Locate each dimension guideline and determine whether a length,
width, diameter, or angle measurement is needed.
4.
Based on new specifications or measurement, mail or fax your
completed drawing at our office, old extrusion tips, enter an
exact measurement in the box corresponding to each dimension
requested. If the hole size is to be concentric with the outside
diameter please specify dimensions of that outside diameter.
5.
Indicate the extrusion tip or die insert material using the
following key :
Insert
Material Key
SCND
-- Single Crystal Natural Diamond
PCD
-- Polycrystalline Diamond
TC
-- Tungsten Carbide
TS
-- Tool Steel |
