As compared to P.C.D. wire drawing dies, T.C. dies are economical
and easily available, so in some cases most of the wire drawing
units prefer to use T.C. Dies like in drawing rod to thinner
diameter, for drawing mild steel, high carbon, stainless steel,
bronze, copper, nickel, aluminium wire & bar etc.
STEEL
CASING OF CARBIDE
WIRE
DIES FOR FERROUS & NON FERROUS METAL |
|
|
|
1.
Longer Die Life & Uniform
Quality |
- |
More
Die re-boring capacity from 100 to 1000 micron. |
| 2.
Lower Die inventories |
- |
Reduce
Die Maintenance. |
|
3.
Fewer production
interruptions. |
- |
Consistent
wire finish. |
| 4.
Less scrap |
- |
Improved
wire-shape / dimensional control. |
| 5.
Better wire quality |
- |
Significant
material saving. |
With experience of 35 years, Ajex has technically improved to
quality of T.C. Dies and is offering one of the best dies to
obtain the maximum output.
Besides providing best profile and mirror polish of Dies
according to customers requirement with an experience of 35 years
in T.C. Dies, Ajex now introduces a special RING protection on die
casting which will not allow the pellet to run out while drawing
(due to heat generated), which is a very common problem.
While ordering for the PCD-DIAMOND-CARBIDE DIES customer should
specify the following points to enable us to supply best Dies.
-
Nib size
-
Casting size with drawing
-
Taper in casting
-
Metal to be drawn
-
Percent of reduction of Wire
-
Number of piece for each size.
|